2020. 2. 16. 23:00ㆍ카테고리 없음
Asterisk Admin GUI v13Supported devicesAsterisk Admin GUI v13GENERAL INFORMATIONAsterisk Admin GUI is an open source interface for configuring the Asterisk PBX server. The Asterisk Admin GUI interface can vary slightly depending on which distribution you use. This may be directly from the Asterisk Admin GUI website or through one of the major Asterisk distributions such as trixbox, Elastix, PBX in a Flash, etc.With Asterisk Admin GUI you are able to configure most of Asterisk's options without editing the individual configuration files. You can also setup advanced options such as call routing, voicemail, and other calling features in a more manageable interface. Below we provide some resources you can visit to obtain further information.Please note that Callcentric is not responsible for preventing unwanted physical or remote access your IP PBX. If your IP PBX is compromised then you will be responsible for any damage caused.Please be sure to read this guide regarding.RESOURCESWebsitesHelp / SupportConfiguring Asterisk PBX (chansip) using the Asterisk Admin GUI interfaceHere we will configure Asterisk through the Asterisk Admin GUI administrative interface to properly route both incoming and outgoing calls to and from Callcentric.
This guide assumes that you have installed Asterisk Admin GUI using either the Asterisk Admin GUI package (or distro), Elastix, IncrediblePBX or a method of your choice. This guide also assumes that the Asterisk Admin GUI install steps were completed properly and that you have administrative access to the Asterisk Admin GUI administration interface.This guide is based on version 13.0.113 of the Asterisk Admin GUI (running Asterisk 13.7.1)We recommend that you read each step through in its entirety before performing the action(s) indicated in the step.We also recommend that you check which version of Asterisk your PBX is based on; as there are many significant changes between each revision of Asterisk. To check which version your PBX is based on; please log into your PBX's command line interface and execute the command 'show version' or 'core show version', and you should see an output similar to the following:Asterisk 13.5.0 built by root @ server on a i686 running Linux on 2015-08-10 13:54:19 UTCSTEP 1Trunk ConfigurationIn the context of this guide a trunk is used to route calls between your Asterisk PBX and your desired VSP (Voice Service Provider), in this case Callcentric.
Asterisk Sip Trunk Setup
How to configure SIP Trunking for Asterisk IP PBX based systemsOur service is 100% compatible with Asterisk using either standard SIP registration or IP authentication where SIP trunks are configured as such. Asterisk is the base software behind many open-source PBX distributions, including FreePBX, Trixbox and Elastix, and is also the enabler behind many other ITSPs and commercial PABX manufacturers.This guide is aimed at Asterisk's SIP stack via the sip.conf file, it does not deal with real-time configuration via a back-end database, however, the principles are the same and the appropriate options should be transposed as such.